Viking Built-In Especificações descarregar pdf (Página 13)

SSaavviinngg EEnneerrggyy

You can help your unit use less electricity.

•Clean the condenser coil regularly.

•Open the door as few times as possible. Think about what you need

before you open the door. Get everything out at one time. Keep

food organized so you will not have to search for what you want.

Close door as soon as food is removed.

•Don’t overcrowd the unit so air movement is blocked.

•Don’t set the unit to temperature colder than necessary.

UUnnddeerrssttaannddiinngg SSoouunnddss YYoouu MMaayy HHeeaarr

Your new unit may make different sounds than your old one. Hard

surfaces, such as the ceilings, walls, and cabinets around the unit can

make sounds seem louder. These sounds are normal and will soon

become familiar. These sounds also indicate unit is operating and

performing as designed.

•

FFrreeeezzeerr oorr RReeffrriiggeerraattoorr ffrreesshh ffoooodd ffaann --

air rushes and whirls.

•

SSeeaalleedd ssyysstteemm --

(evaporator and heat exchanger) refrigerant flow

gurgles, pops or sounds like boiling water.

•

DDeeffrroosstt hheeaatteerr --

sizzles, hisses or pops.

•

CCoonnddeennsseerr ffaan

n --

air rushes and whirls.

•

CCoommpprreessssoorr --

has a high pitched hum or pulsating sound.

•

IIccee ccuubbeess --

from ice maker drop into ice bin.

•

IIccee mmaakkeerr vvaallvvee hhooookkuupp --

buzzes when ice maker fills with water. This

occurs whether or not All Freezer is connected to water supply. If All

Freezer is not connected to water supply, stop sound by raising ice

maker arm to OFF position.

•Foam insulation is very energy efficient and has excellent insulating

capabilities. However, foam insulation is not as sound absorbent as

previously used fiberglass insulation.

LLoowweerr LLiigghhtt BBuullbbss ((AAllll FFrreeeezzeerr))

1. Disconnect power at breaker or turn power disconnect switch to off.

2. Remove center freezer basket and frame by lifting up on the black

leveler on each side until drawer disengages from glide.

3. Lightly grasp light cover on the underneath side and pull up.

4. Replace with an incandescent, medium base tubular bulb with a

maximum of 40 watts.

5. Replace cover by engaging the top of the light cover over the light

bracket. Once engaged, snap the bottom of the light cover over

the light bracket with light pressure.

6. Replace center freezer basket and frame by aligning the inner glide

on the basket with the outer glide in the unit. Slide freezer basket

and frame back until black leveler “clicks”.

7. Reconnect power or turn power disconnect switch to ON position.

Black

Leveler

LLoowweerr LLiigghhtt BBuullbbss ((AAllll RReeffrriiggeerraattoorr))

1. Disconnect power at breaker or turn power disconnect switch to off.

2. Lightly grasp light cover on the underneath side and pull up.

3. Replace with an incandescent, medium base tubular bulb with a

maximum of 40 watts.

4. Replace cover by engaging the top of the light cover over the light

bracket. Once engaged, snap the bottom of the light cover over

the light bracket with light pressure.

5. Reconnect power or turn power disconnect switch to ON position.

Light bulb

cover

Light bracket

inner glide that

attaches to

outer glide in

unit

1 2 ... 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários

Viking Built-In Especificações Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Micro-ondas Viking Built-In