Viking Platinum 16 Guia do Utilizador descarregar pdf (Página 16)

Page 16

1. Place a cone or spool of thread on the spool pin. If

using a spool, make sure that the slits on the spool are

against the base of the spool pin holder. Pass the thread

through the thread-stand eyelet from back to front,

continuing to thread guide A. (Figure 8)

2. Continue to the three-hole thread guide B. Beginning

at the top, wrap all three holes from back to front, hand

wheel side to needle side (see Figure 9).

Note: The purpose of the three-hole thread guide B is to

prevent loops of thread coming off the thread cone from going

into the top tension as a knot can cause thread breakage

and bad tension. For most threads on a cone, it is important

to thread all three holes for consistent results and to make

adjustments at the top tension assembly. An exception to

this rule is when working with very delicate threads, such as

holographic or threads that are prone to breakage. You may try

skipping one or two holes on thread guide B when using these

threads.

Figure 8

Figure 9

Threading the Machine

DETAIL D

SCALE 1 : 2

DETAIL G

SCALE 1 : 2

DETAIL C

SCALE 1 : 2

DETAIL D

SCALE 1 : 2

DETAIL G

SCALE 1 : 2

DETAIL C

SCALE 1 : 2

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Sem comentários

Viking Platinum 16 Guia do Utilizador Página 16