Programming
Switch 1 Switch 2 Ring Cadence
OFF OFF Standard: 1 sec on, 3 secs off (default)
ON OFF Double: 1 sec on, 0.5 sec off, 1 sec on, 3.5 sec off
OFF ON Short/Short/Long: 0.5 sec on, 0.5 sec off, 0.5 sec on, 0.5 off, 1 sec on, 3 secs off
ON ON Short/Long/Short: 0.5 sec on, 0.5 sec off, 1 sec on, 0.5 sec off, 0.5 sec on, 3 secs off
C.C. INPUT
N.O. COM N.C.
N.O. COM N.C.
COM N.O. N.C. - - - - AUX.
N.O.
N.C.
N.O.
N.C.
C.O. LINE
C.O.
C. Wiring
CAUTION:
Do NOT install a
W-1000,W-2000A
or W-3000 on a
telephone line
without a C-1000B
Controller
(see DOD# 155).
* Note: The gel-filled (water-tight) butt connectors are de-
signed for insulation displacement on 19-26 guage wire
with a maximum insulation of 0.082 inches. Cut off
stripped wire ends prior to terminating.
** Note: To increase surge protection, loosen the PCB mounting screw labeled (as shown above) and fasten
a wire with spade terminal (included) from the mounting screw to Earth Ground (grounding rod, water pipe, etc.)
*** Warning: The power run wire length is limited to 150 ft of CAT5 wire. Longer power runs will require heavier
gauge wire (doubling or tripling pairs) and/or a higher voltage power adapter. Voltage at the doorbox power input
connections must not exceed 18VAC RMS.
A. DIP Switches
S2 DIP Switch Settings
Switch 1 Switch 2 Ring Output
OFF OFF 2 rings
ON OFF 3 rings
OFF ON 10 rings (default)
ON ON 30 rings
S1 DIP Switch Settings
Switch 3 Communication Mode
OFF Normal Handsfree Mode (default)
ON Push-To-Talk Mode
Note: All switches shown in factory default settings.
B. Handsfree Operation (S1 Dip Switch 3 - OFF)
When the “Call” button is pressed, the call progress LED (on W-1000/W-3000 only) will turn off and the W-Series
Doorbox will begin generating a 20 Hz ring signal. The caller at the Doorbox will hear an audio ring back signal
while the LED flashes. When the inside party has answered, the LED will light until the inside party hangs up. At
that point, the LED will turn off for approximately one second and then light steady to illuminate the W-1000/W-
3000 after dark.
C. Push-To-Talk Operation (S1 Dip Switch 3 - ON)
In extremely noisy locations, the “Push-to-Talk” mode should be used. To switch to the “Push-to-Talk” mode, place
DIP switch 3 in the ON position (see Dip Switch Programming). To initiate a call, momentarily press the “Call”
button to generate the ring signal. After the inside party has answered, press and hold the call button to talk.
Release the call button to listen.
3
(4 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais