Viking 15"W Guia de Instalação descarregar pdf (Página 6)

LEG LEVELER INSTALLATION

1. Tip unit backwards so there is (1) foot of clearance on front of the unit. Have someone to assist you in tilting the

unit, to prevent it from falling on you while installing the leg levelers.

2. Screw front two leg levelers into the screw impressions. Leg levelers should be screwed in until snug.

3. Repeat steps 1 & 2, with the exception of tipping the unit forwards now, to screw in the back two leg levelers.

4. Your leg levelers are now installed.

5. The unit should be level from front to back and side to side. If floor conditions do not allow the unit to sit level,

adjust leg leveler(s) by turning the required leg leveler(s) counter-clockwise to increase their height and clockwise to

reduce their height.

ATTACHING THE OVERLAY PANEL TO THE DOOR

1. If the door is attached to the unit, remove by unscrewing the top Allen head set screw at the top hinge. Remove

the door by angling the door off of the bottom hinge pin.

2. Peel back the door gasket to expose the screw holes.

3. Set the overlay panel flush to the front of the door in the desired location. Clamp the overlay panel to the door if

necessary.

4. Insert the wood screws through the back of the door into the pilot holes in the overlay panel and tighten.

5. Reinstall the door gasket by pressing into the door channel. Make certain the corners are inserted fully.

6. Install the door to the unit. Use the supplied plastic washer as shown in the figure below.

7. Realigning the door may be necessary. Any final door adjustments can be made using a 5/32” Allen head driver to

adjust the door’s brackets. (See figure below)

8. Attach the door to the unit by reversing step number 1 above.

WARNING

Do not lay unit on top, side, back, or front. If unit is accidentally laid in

any position other than right side up, then the unit must remain in the

right side up position for at least 24 hours before plugging the unit in.

1/8” ALLEN HEAD

FOR HINGE

Hinge Hardware Installation Details

BOTTOM OF DOOR

ATTACHED OVERLAY PANEL

DOOR HINGE

ADJUSTMENT SCREWS

(2) NYLON

HARDWARE

COMPONENTS

AT TOP HINGE

TOP HINGE CORNER

OVERLAY PANEL

DOOR HINGE

BUSHING BRACKET

SHOULDER BUSHING

.625 OD X .218 ID

WASHER

BOTTOM HINGE CORNER

REFRIGERATOR

DOOR

OVERLAY PANEL

DOOR HINGE

BUSHING BRACKET

SHOULDER BUSHING

(3) NYLON

HARDWARE

COMPONENTS

AT BOTTOM

HINGE

.75 OD X .443 ID

WASHER

.75 OD X .257 ID

WASHER

SCREWS

ADJUSTMENT

5/32” ALLEN HEAD SCREWS

FOR HINGE ADJUSTMENT

0 3/8” CLEARANCE HOLES

FOR SCREWS

8 HOLES

Ø 3/8” CLEARANCE HOLES

FOR SCREWS - 10 HOLES

MAGNETIC

DOOR GASKET

REAR OF DOOR

Screw

Impressions

CAUTION

Door can become disengaged if washers are not installed.

CAUTION

Door can become disengaged if washers are not installed.

CAUTION

Door may not swing properly if all nylon components are not

installed as shown.

1 2 3 4 5 6 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários

Viking 15"W Guia de Instalação Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Soluções para fazer cubos de gelo Viking 15"W