Viking VCBB5363ELSS Guia de Instalação

InstallationGUIDE5 SERIESProfessional Built-In Bottom-Freezer Refrigerator VCBB5363E / CVCBB5363E

10 Cabinet Information (Professional)DoorWall1–13/16”(4.6 cm)Space if 24” standard cabinet depth is used3/4”(1.9 cm)Full End Panel24”(61.0 cm)Standard

11Cabinet Information (Professional with Flush Mount Trim)Top ViewTop ViewDoor24”(61.0 cm)Standard Cabinet Depth25”(63.5 cm)Countertop DepthWall3/4”(1

12Custom Side Panel Dimensions (Professional)3/4”(1.9 cm)End panel5/32”(0.4 cm)3/16”(0.5 cm)Back fillerpanel22-7/16”(57.0 cm)22-7/16”(57.0 cm)22-1/4”

13Custom Side Panel Dimensions ( Professional with Flush Mount Trim)* Depending on how high leveling feet are raised, and cabinet enclosure height.3/

14 General Information Area RequirementsVerify the following:• Unit can fi t into residence and can be moved around corners and through doorway

15 General Information Water Supply RequirementsUse only 1/4” (6 mm) copper tubing for water line. DO NOT install copper tubing in area where tempera

16 General Information Area Requirements • Most of the unit’s weight is at the top. Extra care is needed when moving the unit to prevent tippi

17 Note: If the unit is to be installed fl ush with the cabinets, the fl ush mount side trim must be installed fi rst. If not, skip to “Installation”.Ste

181278aWall2 x 4RefrigeratorFront of unit21 36 Replace unit top. Replace four side screws. Attach one 2 x 4 to wall stud (refer to dimensions page fo

1911121314 Pull supply tubing forward under unit.Note: DO NOT use plastic water lines. Flush water line by running two quarts of water into a bucket.

2Table of ContentsWarnings and Important Information _______________________________ 3 Professional Bottom-Freezer Dimensions ______________________

2017 Reinstall cabinet trim and screws.15Wall2 x 4RefrigeratorScrew16 Lift unit off rollers to desired height and level unit using a 5/16” head wrenc

21312201221110˚110˚110˚90˚120˚120˚120˚ Open refrigerator door so door stop and shoulder screw are accessible. Note: Shoulder screw should be in 110º d

22 Water Filter System Specifi cation and Performance Data Sheet ContaminantReduction Average Infl uent NSF Specifi ed Challenge Concentration Avg

23 Final Installation Replace the center grille louver.22 Replace top air grille. Using an 8” (20.3 cm) magnetic nut driver, replace the two 1/4” (0.

24 Performance Checklist —Verify cabinet size. — Verify electrical supply and water supply (if applicable). — Install anti-tip device(s) and ve

25Verify Operations Control PanelsBottom Freezer1. Press “ACTIVATE CONTROLS” pad.2. Verify unit is not in Sabbath Mode. If in Sabbath Mode: A.

26Service & Registration If service is required, call your authorized service agency. Have the following information readily available.• Model num

27

F21417A EN Viking Range, LLC111 Front StreetGreenwood, Mississippi 38930 USA(662) 455-1200For product information,call 1-888-(845-4641)or visit our we

33IMPORTANT – Please Read and Follow! • Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying volta

4IMPORTANT – Please Read and Follow! A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, or local ordinance

5WARNING TIP OVER HAZARD Appliance is top heavy and tips easily when not completely installed. Keep doors closed until appliance is completely inst

6 Dimensions (Bottom-Freezer) 36” Bottom-Freezer24”(61.0 cm)35”(88.9 cm)52”(132.1 cm)23–1/16”(58.5 cm)3–19/32”(9.1 cm)36”36”(91.5 cm)(91.5 cm)36”(9

7Specifi cations (Bottom-Freezer)36” Bottom FreezerDescription VCBB/CVCBBOverall width 36” (91.5 cm) Overall height (from bottom) 82-3/4” (210.2 cm

8 Cutout Dimensions (Bottom-Freezer)9”(22.9 cm)73-3/8”(186.4 cm)82–7/8”(210.5 cm) min.anti-tip board &opening height84–1/16”(213.5 cm) max.anti-t

9 Anti-Tip Dimensions (Bottom-Freezer) 36” Bottom-FreezerTwo 2”x 4” Mounting Boards3” (7.6 cm) x 3-1/2” (8.9 cm)NOTE: If unit is installed deeper th